Past projects

Built, poured and proven.

Real installs from around Barrie & Simcoe County — rough-ins, pours and finished systems, photographed on the job, not staged for a brochure.

2016 – 2026 · BARRIE & SIMCOE COUNTY · OXYGEN-BARRIER PEX

Project 01 · BH

Where room-by-room comfort starts

That manifold in the photo is the control center of a radiant home. Every loop of oxygen-barrier PEX runs back to it as its own circuit, so each area gets its own flow — which is how radiant delivers true room-by-room temperature control instead of one thermostat guessing for the whole house. Balanced there, pressure-tested there, and then quietly doing its job for decades.

  • Room-by-room control
  • Oxygen-barrier PEX
  • Pressure-tested loops
Stainless manifold with individual PEX loop circuits, the control centre of the system
BH · MANIFOLD
Floor prepared for PEX heating loops
PEX loops fitted room by room
Heating loops laid before the finished floor goes down
Loop installation in progress
Loop layout following the shape of the room
PEX heating loops covering the floor area
Heated floor taking shape
Loops secured and ready for the floor above
Completed loop coverage

Project 02 · OS

The whole basement, warm underfoot

Basements are where floors feel coldest — so on this build, radiant went across the entire basement floor. The loops are oxygen-barrier PEX laid over insulation, so the heat drives up into the room instead of down into the ground, and the whole floor becomes one big, quiet radiator. Further along, the compact mechanical room that runs it all.

  • Full-basement coverage
  • PEX over insulation
  • Heating + plumbing, one trade
PEX loops covering an entire basement floor over insulation
OS · FULL BASEMENT
Heating loops continuing across the basement floor
Install progress across the basement
PEX loops laid over insulation across a basement floor
Loops running back to the manifold along the basement wall
Basement framed and insulated, ready for radiant loops
The compact mechanical room: boiler, pumps and controls that feed the floor

Project 03 · ME

Even spacing, even warmth

Radiant comfort comes down to a pattern you’ll never see again once the floor goes in: evenly spaced loops over insulation, covering the space edge to edge. Get that spacing right and the floor heats as one surface — no hot stripes, no cold corners — steady warmth in a basement, the space that’s usually coldest in the house. Designed first, then laid exactly to the plan.

  • Edge-to-edge coverage
  • Even loop spacing
  • Insulated below
Evenly spaced PEX loops over insulation across a basement floor
ME · LOOP LAYOUT
Loop placement following the design
Insulation and loop layout detail

Project 04 · From the archive

Same standards, since 2016

Radiant isn’t new to us — this set reaches back a decade. Cameras got better; the fundamentals didn’t change: insulation, tubing, testing, pour. Ten years of the same standards is its own kind of warranty.

A 2016 install from the project archive
PEX loop work from the project archive
An earlier project from the archive
An earlier install from the project archive
A cured heated slab from the project archive

Your project next

Warm floors, in your own home

Every one of these started with a site visit and a heat-loss calculation. Yours would too — book a free consultation and we’ll tell you exactly what radiant would take in your space.